MULTIQUIP SP403030 Specifications download pdf (Page 55)

MQ SP4030 SAW • OPERATION MANUAL — REV. #0 (01/22/09) — PAGE 55

MAINTENANCE

Tips When Draining and Filling the Hydraulic Oil

System

1. It will take 3-4 quarts to fill the hydraulic system when

new and somewhat less when changing the oil.

2. Remove the oil reservoir cap to speed oil draining.

3. When refilling the system, raise the saw halfway up,

then lift the rear of the saw until the blade flanges touch

the ground. This will help to speed the filling process.

4. After filling the system, jack the saw up so the drive

wheels are off the ground. Start the saw and move the

control handle half way into FORWARD to purge air

out of the system.

Slurry Control Strip

If your saw is not already equipped with it, a slurry control

strip is available from the manufacturer. See Figure 65.

Long Term Storage

■

Remove the battery.

■

Drain fuel from fuel tank and fuel lines.

CAUTION — Fuel

Never store the saw with fuel in the tank for any extended

period of time. Always clean up spilled fuel immediately.

1. Slurry Control Strip

2. 3/8" FHSC Screw

3. Flat Washer

4. Nyloc Nut

Figure 65. Slurry Control Strip

■

Clean exterior with a cloth soaked in clean oil.

■

Store unit covered with plastic sheet in moisture and

dust-free location out of direct sunlight.

Decommissioning Saw/Components

Decommissioning is a controlled process used to safely

retire a piece of equipment that is no longer serviceable. If

the equipment poses an unacceptable and unrepairable

safety risk due to wear or damage or is no longer cost

effective to maintain (beyond life-cycle reliability) and is to

be decommissioned (demolition and dismantlement), the

following procedure must take place:

1. Drain all fluids completely. These may include oil,

gasoline, hydraulic oil and antifreeze. Dispose of

properly in accordance with local and governmental

regulations. Never pour on ground or dump down drains

or sewers.

2. Remove battery and bring to appropriate facility for lead

reclamation. Use safety precautions when handling

batteries that contain sulfuric acid. See battery safety

section.

3. The remainder can be brought to a salvage yard or

metal reclamation facility for further dismantling.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60

Comments to this Manuals

No comments

MULTIQUIP SP403030 Specifications Page 55

Comments to this Manuals

Related products and manuals for Mitre saws MULTIQUIP SP403030