MULTIQUIP SP403030 Specifications download pdf (Page 41)

MQ SP4030 SAW • OPERATION MANUAL — REV. #0 (01/22/09) — PAGE 41

MAINTENANCE

Checking Engine Oil

1. Check engine oil level daily before starting the engine.

2. When checking or adding oil, place the machine so

the engine is level.

3. Pull the engine oil dipstick from its holder (Figure 37,

Item 10).

4. Determine if engine oil is low. Oil should be between

the upper and lower limit (add oil) lines.

5. If oil is below the “Add Engine Oil” line, add oil up to

the upper limit on the dipstick. Allow enough time for

any oil to make its way to the oil pan before rechecking.

Changing Engine Oil And Filter

1. Change the engine oil after the first 5 hours of use,

then change every 6 months or 125 hours.

2. Remove the oil filler cap (Figure 37, Item 13), and fill

engine crankcase with recommended type oil as listed

in Table 2. Fill to the upper limit of dipstick.

3. Crankcase capacity with filter replacement is 8 quarts,

(7.57 liters). Refer to Table 9 for recommended viscosity

grade for temperature range.

CAUTION — Do Not Overfill

DO NOT overfill the oil pan with engine oil. Always keep

the engine oil level at the upper limit lines on the dipstick

due to the tilting of the engine during operation.

TEMPERATURE RANGE EXPECTED BEFORE NEXT OIL CHANGE

-20

SAE 15W-40

SAE 20W-50

SAE 10W-30, 10W-40

32 40 60 80 100

-30

-20

-10

20 30 40

SAE 0W-30, 0W-40

SAE 5W-30, 5W-40

Table 10. Recommended Viscosity Grades

Oil Filter (125 Hours)

1. Replace the engine oil filter (Figure 38) every oil change

or 125 hours. Refer to your engine manual for specific

details to perform this operation.

2. Be sure to coat the

seal

of the new oil filter with clean

engine oil.

3. Spin on new filter until seal make contact with surface,

then tighten additional 2/3 to 3/4 turn.

1. Engine Oil Filter

2. Filter Seal

Figure 38. Oil Filter

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 59 60

Comments to this Manuals

No comments

MULTIQUIP SP403030 Specifications Page 41

Comments to this Manuals

Related products and manuals for Mitre saws MULTIQUIP SP403030