MULTIQUIP SP403030 Specifications download pdf (Page 36)

PAGE 36 — MQ SP4030 SAW • OPERATION MANUAL — REV. #0 (01/22/09)

STARTING AND STOPPING THE ENGINE

Starting the Engine

1. Move the speed control handle to the NEUTRAL

position.

2. Set the throttle to IDLE.

3. Make sure the emergency stop button is in the OUT

position.

4. Ensure that water lines are attached and water is

flowing to the saw blade.

5. Turn the ignition switch to the ON position (Figure 29).

6. Wait for the glow plug indicator light to go out. See

Figure 30.

7. Turn ignition switch to the START position; RELEASE

switch after engine starts.

WARNING

DO NOT leave the saw unattended while the engine is

running. NEVER start, park, or leave the saw unattended

on a slope.

CAUTION

Allow the engine to warm up before increasing engine

speed.

DO NOT stop the engine abruptly when hot. Reduce the

throttle to idle and allow the engine to run one or two

minutes before turning the ignition switch off. This allows

the engine to cool down preventing damage to the Turbo

charger.

OPERATION

Figure 29. ON/OFF Switch

1. Engine Oil Pressure Warning Light

2. Engine High Temp Warning Light

3. Glow Plug Warning Light

4. Not Used

5. Air Filter Warning Light

6. Battery Warning Light

Figure 30. Ignition Switch and System Status

8. Allow the engine to warm up for several minutes.

9. Set the throttle to the recommended engine RPM to match

the recommended blade speed of the attached blade.

10. Lower the blade to the cut depth.

11. Move the control handle FORWARD to advance the cut.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 59 60

No comments

MULTIQUIP SP403030 Specifications Page 36