MULTIQUIP SP403030 Specifications download pdf (Page 37)

MQ SP4030 SAW • OPERATION MANUAL — REV. #0 (01/22/09) — PAGE 37

In case of an EMERGENCY, push the RED

EMERGENCY-STOP BUTTON to stop all

functions (Figure 31). Engine will not crank

when emergency stop button is depressed.

Figure 31. Emergency Stop Button

OPERATION

Stopping the Engine

1. When finished with the cut, move the control handle to

the NEUTRAL position.

2. Raise the saw blade out of the cut.

3. Reduce the throttle to idle.

4. Allow the engine to run one or two minutes to let the

engine cool down.

5. To stop the engine, turn the ignition switch to the OFF

position.

Restarting After Running Out of Fuel

The 2011 series Deutz engines do not require bleeding of

the fuel system if the engine is run out of fuel.

To restart the engine:

1. Refill the fuel tank with fresh, clean diesel fuel.

2. Re-prime the fuel system by squeezing the fuel prime

bulb (located inside the console, directly under the fuel

tank), until the fuel primer bulb becomes firm.

3. Crank the engine normally until it starts.

OPERATING SYNOPSIS

BEFORE STARTING — Check all fluid levels. Secure blade

firmly to blade shaft. Make sure all protective guards

are in place and properly mounted. Wear eye, ear

protection and protective clothing.

WATER SUPPLY — Connect water supply to water inlet.

Move water ON/OFF CONTROL to ON position. Adjust

WATER FLOW CONTROL lever to desired position.

Drain watering system in cold weather to prevent

damage due to freezing.

BLADES — Always follow blade manufacturer’s

recommendations for blade selection, speed and

application. NEVER exceed blade manufacturer’s

maximum rated RPM. See previous steps for

detailed blade mounting instructions.

STARTING ENGINE — Set CONTROL HANDLE to

NEUTRAL position. Set THROTTLE to IDLE. Turn start

switch to ON position. Wait for glow plug indicator light

to go out. Momentarily turn switch to start position;

release switch as soon as engine starts. Allow engine

to warm up for several minutes before increasing

engine speed. Use approved diesel fuel only.

STOPPING ENGINE — Do not stop engine abruptly when

hot! Reduce THROTTLE to IDLE and allow engine to

run 1 to 2 minutes before turning ignition switch off.

Damage to engine may occur if not allowed to cool

adequately.

FWD-NEUTRAL-REV CONTROL — The panel mounted

handle controls FORWARD, NEUTRAL AND REVERSE

operation. Neutral position stops or holds saw in a

stationary position. Incremental movement in the

FORWARD or REVERSE direction will increase speed

proportionate to amount of movement.

RAISE-LOWER FUNCTION — RAISE-LOWER function is

controlled by the switch mounted at the right side of

the CONTROL HANDLE. Push toggle switch lever

forward to lower saw. Pull toggle switch lever backward

to raise saw.

BRAKES — This saw is equipped with parking brakes.

Brakes are applied automatically when engine is off

and disengaged when engine is running.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 59 60

Comments to this Manuals

No comments

MULTIQUIP SP403030 Specifications Page 37

Comments to this Manuals

Related products and manuals for Mitre saws MULTIQUIP SP403030