MULTIQUIP SP403030 Specifications download pdf (Page 53)

MQ SP4030 SAW • OPERATION MANUAL — REV. #0 (01/22/09) — PAGE 53

F-N-R CONTROL ADJUSTMENT

Control (cable) adjustment for the F-N-R should not normally

be necessary; however, some adjustment can be made on

each of the rod end adjustment nuts.

HYDRAULIC SYSTEM MAINTENANCE

MAINTENANCE

DANGER — Hydraulic Leaks

NEVER

use your hand to find hydraulic

leaks. Use a piece of wood or cardboard.

Hydraulic fluid injected into the skin must

be treated by a knowledgable physician

immediately or severe injury or death can

occur.

1. Adjustment Nut

2. Rod End

3. Push-Pull Cable

4. Neutral Safety Switch

Figure 61. F-N-R Control Adjustment

Many hydraulic problems are a result of low fluid levels.

Before checking any other possibilities, make sure the

hydraulic fluid level is correct. Hydraulic problems could

be a result of the following:

1. Incorrect hydraulic fluid level.

2. Plugged hydraulic oil filter

3. Loose or leaking fittings.

4. Ruptured/damaged hydraulic lines.

5. Faulty hydraulic pump.

Hydraulic Oil System

1. Check hydraulic oil level daily.

2. When checking or adding hydraulic oil, place the

machine so the saw frame is level to get an accurate

reading.

3. Hydraulic oil should be 1/2" to 1" in the Oil Reserve

when cold.

4. If hydraulic oil level is low add oil to 1/2" to 1".

5. Use 15W-40 premium grade engine oil.

6. Change oil and filter annually. See Figure 62.

Figure 62. Oil Reserve Fill Line

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 59 60

No comments

MULTIQUIP SP403030 Specifications Page 53