MULTIQUIP SP403030 Specifications download pdf (Page 22)

PAGE 22 — MQ SP4030 SAW • OPERATION MANUAL — REV. #0 (01/22/09)

BASIC ENGINE INFORMATION

BASIC ENGINE COMPONENTS

The following refer to basic engine components and their

functions that an operator may need to reference. The

manufacturer’s engine manual provides further instructions

and details of operation and servicing. The engine shown

in Figure 6 is a Deutz F2L2011 engine.

1. Fuel Filter — Removes dirt and water from the engine

fuel.

2. Governor Lever — This lever restricts engine speed

(high idle and low idle) through a speed control device

linked to the accelerator system.

3. Oil Dip Stick — Remove to check amount and

condition of oil in crankcase.

4. Oil Filter — Spin-on type, filters oil for contaminants.

5. Oil Drain Plug — Remove plug to drain crankcase

oil.

6. Oil Filler Port — Remove to add fresh crankcase oil.

7. Crankshaft V-Pulley — Check fan V-belt between V-

Pulley and fan to determine proper belt tension.

8. Cooling Fan — Driven by the V-belt, the cooling fan

cools the engine by cooling engine oil that circulates

through the engine block and cylinder head.

9. V-belt Tension Adjustment — This bolt provides

means to adjust the V-belt tension at the alternator

bracket.

10. V-belt (Fan belt) — Driven by the engine crank during

operation, drives the fan as well as the alternator.

11. Oil Fill Cap — Remove to add engine oil.

12. Lifting Eye — The lifting eye is provided if the removal/

installation of the engine becomes necessary.

13. Alternator — Located inside the fan assembly. Provides

current to the electrical system and charges the battery.

Driven by means of a crankshaft/V-belt pulley system.

14. Starter — Starts engine when ignition key is rotated

to the “START” position.

15. Flywheel — Main power is taken off from the flywheel

end.

16. Air Intake Port — Provides air from the air cleaner to

the turbocharger unit.

17. Throttle Cable — Provides direct control of engine

throttle lever from throttle control located on the console

control panel.

18. Air Cleaner Assembly — Provides clean filtered air

to the air intake port.

Figure 6. Basic Engine Components

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 59 60

Comments to this Manuals

No comments

MULTIQUIP SP403030 Specifications Page 22

Comments to this Manuals

Related products and manuals for Mitre saws MULTIQUIP SP403030