MULTIQUIP MDR-9DYE User Manual download pdf (Page 28)

PAGE 28 — MQ-MIKASA MDR-9DYE VIBRATORY ROLLER — PARTS & OPERATION MANUAL — REV. #0 (12/19/03)

MDR-9DYE—MAINTENANCE

If the neutral position of the travel lever and the neutral point of

transmission do not match after adjustment is repeated, align as

follows:

1. Loosen the hex socket head bolt M10 used for mounting the

control lever on the underside of the transmission (Figure

37).

2. For forward movement, move the control lever slightly to the

left.

3. for backwards movement, move the control lever slightly to

the right.

Figure 37. Unscrewing Left Lock Nut

FOR YOUR SAFETY:

ALWAYS wear a face shield to avoid acid getting into the

eyes. If acid gets in contact with eyes, flush immediately with

clean water and get medical advice.

Wear rubber gloves and protective clothes to keep acid off

skin. If acid gets in contact with skin, wash off immediately

with clean water.

Use a flashlight to check battery electrolyte level. ALWAYS

check the engine is stopped.

DO NOT charge battery or jump-start engine when the

battery is frozen. Warm the battery to 15 degrees F or battery

may explode.

Replace the battery with the same or similar capacity battery

or battery may explode.

Figure 38. Battery Connection

Positive

Terminal

Negative

Terminal

BATTERY MAINTENANCE

DANGER :

Lead-acid battery contains

sulfuric acid, which may damage

eyes or skin on contact.

DO NOT close the exhaust outlet of battery. The gas pressure

building up in the battery may cause explosion.

Before using a battery charger, read and understand the

charger instruction manual thoroughly.

Charge the battery in a non-spark, well-ventilated area. Avoid

fire from cigarette sparks or matches.

1. If a battery has not been used for some time, reduce

the charge level initially to protect each plate inside

the battery.

2. Check the battery terminals periodically to ensure

that they are in good condition.

3. Use wire brush or sand paper to clean the battery

terminals.

4. Check battery for cracks or any other damage. If white

pattern appears inside the battery or paste has

accumulated at the bottom, replace the battery.

5. Measure the specific gravity of electrolyte:

completely charged: 1.270 - 1.290

needs charging: 1.260 or lower

6. If the machine will not be in operation for a long

period of time, charge the battery sufficiently, tighten

all caps, correctly, store in cool dry place and check

the battery charge level every month to maintain the

performance of the battery.

BATTERY CABLE CONNECTION

1. When removing cable, disconnect the ground side

(normally negative) first (Figure 38).

2. When installing cable connect the ground side (normally

negative) last.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 89 90

Comments to this Manuals

No comments

MULTIQUIP MDR-9DYE User Manual Page 28

Comments to this Manuals

Related products and manuals for Engine MULTIQUIP MDR-9DYE