MULTIQUIP MDR-9DYE User Manual download pdf (Page 20)

PAGE 20 — MQ-MIKASA MDR-9DYE VIBRATORY ROLLER — PARTS & OPERATION MANUAL — REV. #0 (12/19/03)

CHECKING SCRAPER BAR

1. Check scraper bar and make sure that they are not clogged

with mud, bent or damaged (Figure 6).

2. Adjust clearance between drums and scrapers as

necessary.

CHECKING BOLTS, NUTS, AND SCREWS

1. Check bolts, nuts, and screws on various parts of the

machine, including the engine, for proper tightness.

Be careful not to confuse the water tank with the

oil tank.

CAUTION :

POSITIONING THE HANDLE BAR

1. Release the handle bar release pin (Figure 15) and position

the handle bar to the lowered position before starting

operation.

2. When machine is not in use, release the handle bar release

pin and position the handle bar to the upright position.

CHECKING LEVERS

1. Check travel and vibrator levers to make sure they are

functioning properly (Figure 6).

2. With travel lever placed in reverse, push the deadman

device and verify that the travel lever returns to neutral

position. The travel lever stays in neutral position once the

deadman device is released.

CHECKING WATER TANK

1. Check the water tank to see if filled. Add water if necessary.

The water tank has a capacity of approximately 6 gallons

(23 liters) (Figure 14).

Figure 14. Water Tank Check

Figure 15. Handle Bar Positioning

MDR-9DYE — INSPECTION

INITIAL STARTUP (ENGINE)

Electric Start

1. On the handle bar:

A. Move the

travel lever

to the NEUTRAL position.

B. Move the

vibrator lever

to the OFF position.

2. Open the fuel cock by turning it clockwise to the

down position (Figure 16).

Figure 16. Open Fuel Cock

Handle Bar

Release Pin

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 89 90

Comments to this Manuals

No comments

MULTIQUIP MDR-9DYE User Manual Page 20

Comments to this Manuals

Related products and manuals for Engine MULTIQUIP MDR-9DYE