Multiquip CA4HM User Manual download pdf (Page 20)

PAGE 20 — CA4HM WALK-BEHIND TROWEL — OPERATION MANUAL — REV. #3 (10/28/10)

3. Place the

choke lever

(Figure 10) in the "

CLOSED

" position

if starting a

cold

engine.

This section is intended to assist the operator with the initial

start-up of the walk-behind trowel. It is extremely important that

this section be read carefully before attempting to use the trowel

in the field.

DO NOT use your trowel until this section is thoroughly

understood

Starting the Engine

1. Place the engine

fuel valve lever

(Figure 8) to the "ON"

position.

Figure 8. Engine Fuel Valve Lever

Lifting the Trowel Onto a Slab

Extra care should be taken when lifting the trowel off the ground.

Serious damage to the machine or personal injury could be

caused by dropping a trowel.

Figure 11. Engine Choke Lever (Open)

Figure 10. Engine Choke Lever

5. Place the

engine ON/OFF switch

(Figure 12) in the "

position.

Figure 12. Engine ON/OFF Switch

4. Place the

choke lever

(Figure 11) in the "

OPEN

" position if

starting a

warm engine

or the

temperature is warm.

2. Place the trowel's

throttle lever

(Figure 9) to the "IDLE"

position.

Figure 9. Throttle Lever (Idle Position)

OPERATION

NEVER attempt to lift this machine alone. NEVER lift the

trowel by the guard ring as it may rotate and cause injury.

ALWAYS make certain the folding handle is secure and use

only the manufaturer's approved lifting points. The trowel

may be lifted at the center lifting bale by crane or other lifting

device of adequate capacity.

WARNING

DO NOT attempt to operate the trowel until the Safety,

General Information and Inspection sections of this manual

have been read and thoroughly understood.

CAUTION

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Comments to this Manuals

No comments

Multiquip CA4HM User Manual Page 20

Comments to this Manuals

Related products and manuals for Equipment Multiquip CA4HM