MULTIQUIP MVC98D2 User Manual download pdf (Page 23)

MVC98D2 PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #1 (1/12/11) — PAGE 23

Vibrating Case Oil Replacement (300 Hours)

Figure 20. V-Belt Check

Figure 21. Oil Level Check Plug

Checking and Replacing the Clutch

Checking the Clutch

1. With belt cover removed, visually check outer drum of the

clutch for seizure and "V" groove for wear or damage.

2. Clean the "V" groove as necessary.

3. Check the clutch lining and shoe for signs of wear. If the shoe

is worn, replace the clutch to prevent deficient power

transmission and slippage.

Replacing the Clutch

1. Place a 19 mm offset wrench or the like onto the lower vibrator

pulley fastening bolt.

2. While pulling back hard on the V-belt near the lower vibrating

pulley, rotate offset wrench clockwise so that the V-belt slips

off the lower vibrator pulley. Set V-belt aside.

3. Remove bolt at engine power output by giving a shock to an

engaged wrench (e.g. tapping with hammer) and rotate the

bolt counterclockwise.

4. Remove clutch with a pulley extractor.

5. To install a new clutch, reverse steps 1-4.

1. Place the plate compactor horizontally on a flat surface.

2. Remove oil drain plug (Figure 21) from vibrator and drain oil

from the vibrating case.

3. Using a funnel, fill vibrating case with SAE10W-30 motor

oil.The oil level should be up to the oil plug. The vibrator holds

140 cc (approximately 1 pint).

4. Re-install oil drain plug into vibrator.

Mikasa

VIBRATOR

REMOVE

V-BELT

V-BELT COVER

MAINTENANCE

Always clean the area around the vibrator oil plug (oil level

check) hole before removing plug. This will prevent dirt and

debris from entering the system.

CAUTION

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 63 64

No comments

MULTIQUIP MVC98D2 User Manual Page 23