MULTIQUIP MVC98D2 User Manual download pdf (Page 16)

PAGE 16 — MVC98D2 PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #1 (1/12/11)

Compactor Instructions

The purpose of this section is to assist the user in the setting

up of a NEW compactor

. If your compactor is already

assembled (vibration handle), then this section can be

skipped.

Before packaging and shipping this MQ Mikasa Walk-Behind

Plate compactor was run and tested at the factory. If there

are problems, please let us know.

Steering Handle Assembly

The steering handle is not attached to the compactor’s lower

base at the time of shipment. To attach the steeering handle

to the lower base assembly perform the following:

1. Remove the bolts and washers (handle mounting hard-

ware) from both sides of the plate compactor (Figure 4).

2. Position the anti-vibration handle over the compactor.

3. Align the holes at the bottom of the handle to the holes

on the compactor (lower base) where the bolts and wash-

ers where removed. Install and tighten the bolts and

washers.

HANDLE MOUNTING

HARDWARE

ANTI-VIBRATION

HANDLE

BASE PLATE

Figure 4. Installing the Steering Handle

SETUP

The new plate compactor cannot be put into service until

the setup installation instructions are completed. These

setup instructions only need to be performed at the time

of unpacking a NEW compactor.

NOTICE

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

No comments

MULTIQUIP MVC98D2 User Manual Page 16