MULTIQUIP MVC98D2 User Manual download pdf (Page 19)

MVC98D2 PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #1 (1/12/11) — PAGE 19

Starting the Engine

1. Open the fuel cock

(Figure 11).

2. Move the engine speed control lever (Figure 12) to the

IDLE position.

Figure 12. Engine Speed Control Lever (Idle Position)

4. Grasp the starter grip (Figure 14) and slowly pull it out. The

resistance becomes the hardest at a certain position, corre-

sponding to the compression point. Pull the starter grip briskly

and smoothly for starting.

3. Push down the decompression lever (Figure 13) and re-

lease.

This section is intended to assist the operator with the

initial

start-up

of the compactor. It is extremely important that this

section be read carefully before attempting to use the compactor

in the field.

Figure 14. Starter Grip

Figure 13. Decompression Lever

Figure 11. Fuel Cock

5. If the engine does not start, repeat steps 1 thru 4.

Figure 15. Speed Control Lever (Fast Position)

FAST

ENGINE SPEED

CONTROL

LEVER

IDLE

ENGINE SPEED

CONTROL

LEVER

Operation

1. Once the engine has started, move the engine speed lever

quickly

to the

FAST

(Figure 15) position.

2. With the engine speed control lever placed in the FAST

position, the engine speed should be between 2,300 ~2,600

RPM’s, therefore engaging the centrifugal clutch.

OPERATION

ALWAYS

move the throttle lever quickly without

hesitation, because increasing the engine speed slowly

causes the clutch to slip.

NOTICE

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 63 64

Comments to this Manuals

No comments

MULTIQUIP MVC98D2 User Manual Page 19

Comments to this Manuals

Related products and manuals for Engine MULTIQUIP MVC98D2