MULTIQUIP Chainsaw ONE-WAY PLATE COMPACTOR User Manual download pdf (Page 15)

MVC77 PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #4 (1/14/11) — PAGE 15

Before Starting

1. Read safety instructions at the beginning of manual.

2. Clean the compactor, removing dirt and dust. Particularly, the

bottom of the plate, engine cooling air inlet, carburetor and

air cleaner.

3. Check the air filter for dirt and dust. If the air filter is dirty, blow

through the air filter cartridge from the inside, moving a jet of

dry compressed air up and down until all dust is removed.

Otherwise replace air filter with a new one.

4. Check carburetor for external dirt and dust. Clean with dry

compressed air.

5. Check fastening nuts and bolts for tightness. Loosened

screws or bolts due to vibration, could lead to unexpected

accident.

Engine Oil Check

1. To check the engine oil level, place the plate compactor on

secure level ground with the engine stopped.

2. Remove the filler cap/dipstick from the engine oil filler hole

(Figure 3) and wipe it clean.

Figure 3. Engine Oil Dipstick

3. Insert and remove the dipstick without screwing it into the filler

neck. Check the oil level shown on the dipstick.

4. If the oil level is low (Figure 4), fill to the edge of the oil filler

hole with the recommended oil type (Table 3). Maximum oil

capacity is 400 cc.

Figure 4. Engine Oil Dipstick

Gasoline Check

1. Remove the gasoline cap located on top of fuel tank.

2. Visually inspect to see if fuel level is low. If fuel is low, replenish

with unleaded fuel.

3. When refueling, be sure to use a strainer for filtration. DO

NOT top-off fuel. Wipe up any spilled fuel.

Vibrator Oil Check

1. Place the MVC77 Series plate compactor horizontally on a

flat surface. Make sure the compactor is level when checking

the oil in the vibrator assembly.

2. Check vibrator oil level by removing the plug (vibrator oil gauge)

as shown in Figure 5. The oil level should be up to the oil plug.

The vibrator holds 140 cc (approximately 1 pint). IMPORTANT,

if oil is required, replace using only SAE 10W-30 motor oil.

UPPER LIMIT

LOWER LIMIT

epyTliO.3elbaT

nosaeS erutarepmeT epyTliO

remmuS rehgiHroC°52 03-W01EAS

llaF/gnirpS C°01~C°52 02/03-W01EAS

retniW rewoLroC°0 01-W01EAS

Figure 5. Vibrator Oil Plug

INSPECTION

NOTICE

The Oil Alert system will automatically stop the engine

before the engine falls below safe limits. Always be sure

to check the engine oil level prior to starting the engine.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 71 72

Comments to this Manuals

No comments

MULTIQUIP Chainsaw ONE-WAY PLATE COMPACTOR User Manual Page 15

Comments to this Manuals

Related products and manuals for Engine MULTIQUIP Chainsaw ONE-WAY PLATE COMPACTOR