MULTIQUIP GB2000 Specifications download pdf (Page 19)

GB2000 BALLOON LIGHT• OPERATION AND PARTS MANUAL — REV. #3 (08/30/12)— PAGE 19

TYPE 2 COMPONENTS (S/N G1900119 AND ABOVE)

Figure 4. GB2000 Components

(Type 2 S/N G190019 And Above)

1. Lamp Fixture — Made of heat resistant polyester

balloon, with a diameter of 35.5 inches (902 mm) and

two 1000 watt metal halide lamps.

2. Locking Pin — Locks the lamp ﬁxture in place when

attached to the pole on the bracket.

3. Balloon Power Cable — Provides AC power to the

lamps, fan and baloon inﬂation circuit.

4. Adapter Plate — Attaches to the T-Bar and mast

interface of the light tower to allow the GB2000 to be

installed.

5. Junction Box — Holds the electrical connection and

cables to connect the lamp ﬁxture to the T-Bar and to

the power cable.

6. Support Bracket — Attaches to T-Bar to support

adapter plate (hardware not shown).

7. Connector Caps — Provides protection to the

receptacles on the junction box when not in use.

8. Fan Power Cable — 38 ft. (11.5 meters) cable that

provides 120 VAC from a GFCI receptacle (generator)

to the T-Bar mounted junction box to run the balloon

fan and inﬂate the balloon.

NOTICE

Type 2 adapter plate ﬁts most conventional light tower

masts.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

No comments

MULTIQUIP GB2000 Specifications Page 19