MULTIQUIP GB2000 Specifications download pdf (Page 36)

PAGE 36 —GB2000 BALLOON LIGHT• OPERATION AND PARTS MANUAL — REV. #3 (08/30/12)

MAINTENANCE

REPLACING LAMP

1. Unzip the zipper at the bottom of the balloon and roll

the balloon up to expose the lamp. See Figure 33.

Figure 33. Exposing Balloon

2. Release the lamp guard hooks from the poles and

remove the two lamp guards. See Figure 34.

Figure 34. Removing Lamp Guard

DANGER

Never attempt to replace lamp in a wet place. The

possibility exists of electric shock.

WARNING

Always allow sufﬁcient time for the lamp to

cool down before replacing. The possibility

exists of severe burns if hot lamp is

touched.

CAUTION

Always shutdown power source and remove balloon

assembly from mast when replacing a broken lamp.

Utmost care should be taken in handling broken lamp.

The possibility exists of serious injury from handling a

broken lamp.

BALLOON

ZIPPER

LAMP GUARD

LOCK HOOK

3. Press the tabs on the lamp holder and push up lamp

holder to release it from lamp. Do the same to the lower

lamp if necessary. See Figure 35.

Figure 35. Lamp Holder

4. Remove lamp from the lamp socket by turning lamp

counterclockwise. See Figure 36.

Figure 36. Removing Lamp

5. Install new lamp into socket and turn lamp in a

clockwise direction until tight. See Figure 37.

Figure 37. Installing New Lamp

LAMP HOLDER

LAMP

HOLDER

STOPPER

LAMP

LAM

SOCKET

LAMP

LAM

SOCKET

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 51 52

Comments to this Manuals

No comments

MULTIQUIP GB2000 Specifications Page 36

Comments to this Manuals

Related products and manuals for Work lights MULTIQUIP GB2000