MULTIQUIP DCA-500SSK Specifications download pdf (Page 52)

PAGE 52 — DCA-500SSK — PARTS AND OPERATION MANUAL (STD) — REV. #1 (04/14/01)

14. Set the engine speed switch (Figure 46) to low to idle

engine, set to high when a load is being applied.

17. Observe the generator's ammeter (Figure 49) and

verify that it reads the anticipated amount of current

with respect to the load. Remember the ammeter

will only display a current reading if the load is in

use.

18. The generator will run until manually stopped or an

abnormal condition occurs.

DCA-500SSK — GENERATOR START-UP PROCEDURE (MANUAL)

Figure 48. Main and GFCI Circuit Breakers

Figure 46. Engine Speed Switch

15. The tachometer (Figure 47) will indicate the speed of

the engine when the generator is operating. Under

normal operating conditions this speed should be

approximately 1800 RPM’s.

16. Turn the MAIN, GFCI and LOAD circuit breakers to

their ON position (Figure 48).

Figure 47. Engine Tachometer

Figure 49. Ammeter (Load)

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 113 114

No comments

MULTIQUIP DCA-500SSK Specifications Page 52