MULTIQUIP QP-301TH Specifications download pdf (Page 24)

PAGE 24 — QP-301TH TRASH PUMP — PARTS MANUAL — REV. #4 (10/05/05)

QP-301TH — PREPARATION FOR LONG -TERM STORAGE

Pump Storage

For storage of the pump for over 30 days, the following is

required:

Drain the fuel tank completely.

Run the engine until the fuel in the injection system is

completely consumed.

Completely drain used oil from the engine crankcase

and fill with fresh clean oil, then follow the procedures

described in the engine manual for engine storage.

Remove the drain plug from the pump and drain out any

water from left in the housing.

Remove the pump cover and clean inside of pump

housing. Coat inside of pump housing with a light film of

oil to reduce corrosion. A spray can of oil works well for

this application.

Cover suction and discharge ports with duct tape to

prevent any foreign matter from falling into pump.

Cover pump and engine with plastic covering or

equivalent and store in a clean, dry place.

To protect the water cooled-seals, place one-half pint of

lubricating oil (new or used) through the discharge opening

on the pump and crank the engine several times. This

will prevent excessive corrosion and also keep the

mechanical seal lubricated.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 69 70

No comments

MULTIQUIP QP-301TH Specifications Page 24