MULTIQUIP EM120P series Specifications download pdf (Page 12)

PAGE 12 — ESSICK EM-120PM— PARTS & OPERATION MANUAL — REV. #4 (05/24/05)

EM-120PM — ELECTRIC MOTOR

ELECTRIC MOTOR

For lubrication care and operation of the electric motor, refer to

your electric motor instruction booklet furnished with the motor.

Protect the electric motor from dust as much as possible and

keep ventilating openings clean.

The electric motor for this mixer is available in either a 5 HP

single-phase or 5 HP 3-phase configuration. The input voltage

requirement for these motors is either 230 VAC or 440 VAC only.

ELECTRIC MOTOR CONNECTION

A 12 inch electrical cable (Figure 2) with a pigtail at one end is

provided with the electrical motor for hookup to a power source.

Table 1. shows the required NEMA connector for the desired

motor horsepower rating. In addition, Table 2 also shows the

matching NEMA approved connector for the required extension

cord.

CAUTION:

■

DO NOT spray water at any time on the

electric motor

■

DO NOT operate electric motor in a

explosive environment.

NOTE

It is strongly recommended that all electrical wiring be

done by a

licensed electrician

. Special attention

should be given to the electric switch as well as the

over-and-under voltage protection devices as per

regulations set forth in the local electrical safety code

handbook.

Figure 2. Single Phase Electric Motor with 12 inch Pigtail Cable

noitamrofnIgniriWrotoMcirtcelE.2elbaT

rotoM

rewopesroH

gnitaR

esahPelgniS-tloV032

rotcennoCgulPAMENAMENgnitaM

rotcennoCelcatpeceR

PH3935049N/PP02-6

L045049N/PR02-6L

PH5745049N/PP03-6L845049N/PR03-6L

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Comments to this Manuals

No comments

MULTIQUIP EM120P series Specifications Page 12

Comments to this Manuals