MULTIQUIP DCA-45SSIU3 Specifications download pdf (Page 34)

PAGE 34 — DCA45SSIU3 50 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #2 (12/19/08)

GENERATOR START-UP PROCEDURE

BEFORE STARTING

Place the 1. main, G.F.C.I., and aux. circuit breakers (Figure

35) in the OFF position prior to starting the engine.

Main, Aux. and GFCI Figure 35.

Circuit Breakers (OFF)

Make sure the 2. voltage change-over board has been

conﬁ gured for the desired output voltage.

Connect the load to the 3. receptacles or the output

terminal lugs as shown in Figure 10. These load

connection points can be found on the output terminal

panel and the output terminal panel’s hard wire hookup

panel.

Tighten terminal nuts securely to prevent load wires 4.

from slipping out.

Close all engine enclosure doors (Figure 36).5.

Engine Enclosure DoorsFigure 36.

CAUTION

The engine’s exhaust contains harmful emissions.

ALWAYS have adequate ventilation when operating.

Direct exhaust away from nearby personnel.

WARNING

NEVER manually start the engine with the main, GFCI or

auxiliary circuit breakers in the ON (closed) position.

INCORREC

CORRECT

STARTING

Place the1. voltage selector switch in the desired

voltage position (Figure 37)..

Voltage Selector SwitchFigure 37.

Preheat the engine glow plugs by turning the ignition 2.

key (Figure 38) to the “OPERATION” position.

Ignition Switch Figure 38.

(Operation/PreHeat Position)

When the preheat lamp illuminates (Figure 39), turn the 3.

ignition key to the “start” position. Once the engine

starts, release the ignition key and allow it to return to

the “operation” position (Figure 38).

Pre-Heat LampFigure 39.

Let the engine run for 3-5 minutes, listen and check 4.

for any abnormal sounds or smells. Check for fuel

leaks, and noises that would associate with a loose

cover or hardware. If any of the above mentioned

conditions exists, shut-down the engine and correct

the problem.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 77 78

Comments to this Manuals

No comments

MULTIQUIP DCA-45SSIU3 Specifications Page 34

Comments to this Manuals

Related products and manuals for Power generators MULTIQUIP DCA-45SSIU3